Blastking D600.4 2400 Watt 4 Channel Class D Amplifier
Equipped with Blastking’s Proprietary SPM Self Protection Mode Technology
Output Power (8 Ohm): 300W x 4
Output Power (4 Ohm): 600W x 4
Output Power Bridge (8 Ohm): 900W x 2
Output Circuit Type: CLASS D
Input Impedance: 10K Ohm
Frequency Response: 20Hz-20KHz
THD 20hz~20khz(8 Ohm): 0.1%
Slew Rate: 40V/usec
Hum And Noise: 100dB
Damp Modulus (8 Ohm): >200
Radiator: High/Low Automatism Control
Dimension 19” x 8.5” x 2.5” / 483 x 215 x 64 mm (1.5U)
Power Range 110V / 220V Switchable
Overload Protection
The Club Series is equipped with Blastking’s proprietary SPM (Self Protection Mode) technology which protects the
output power against damage.
When the amplifier channel output current exceeds its specified peak current output, the current will be limited by the
protector to work within the specified range.
In the event the amplifier channel current output exceeds its specified peak current output, the amplifier will be
disabled (muted) for 1000ms and automatically re-start after the short circuit state disappears.
Overload Voltage Protection
When the working voltage exceeds the maximum working voltage or lower than the minimum working voltage, the
amplifier enters intp protection mode, and turns off the power supply.
Note: Working over 240 Volts AC for a long period of time may cause power damage.
Power Control
The Club series power amplifier supports power output control: according to the panel setting power, the connected
speaker can be operated safely and reliably within the power requirements.
