Take your performance to the highest levels... Axial Pro Series
- Lightweight Class D Power Amplifier
- 1U Rack Space
- Function Indicators and Short Circuit Protection
- Handles 2 Ohm Loads
- Precision Rotary Level Controls and Power Switch
- 97% Power Efficiency
- 110-220V, 50/60Hz Switch selector
- 8 Ohm Stereo: 4x2000 Watts
- 4 Ohm Stereo: 4x3400 Watts
- 2 Ohm Stereo : 4x4760 Watts
- 16 Ohm Bridge: 2x4000 Watts
- 8 Ohm Bridge: 2x6800 Watts
- 4 Ohm Bridge: 2x9520 Watts
- Input: XLR
- Output: NL4 Speakon
- Dimension (WxHxD): 19?x1.7?x18.3? (483x44x465 mm)
- Weight: 28.7 lbs (13 Kg)
1. VOLUME CONTROL
- Calibrated potentiometers to alter the total gain of the power amplifier. In order to avoid distortions in mixing consoles, these controls should normally be positioned between 0 and 10. The calibrated markings show the additional attenuation directly.
2. LED SIGNAL
- Green LED: The input signal is greater than "-32dB"
- Yellow LED: The output signal is distorted by more than 1%, or the power is compressed
- Red LED: Protection mode. Please turn down the unit
3. LED POWER
- Green LED: Power switch is turned on
- Yellow LED: The temperature limiter is on
4. POWER SWITCH
- Turn the unit power on or off.
1. POWER SUPPLY INPUT D16K
- 3x2.5mm² Power cord D10K: 3x1.5mm² Power cord
2. SPEAKON
- Four core SPEAKON speaker socket: When the amplifier is in Stereo mode, CHA\CHB will connect through this socket, the method is below: 1+, 1-.
3. DIP SWITCHES
- GAIN SWITCH Set to 41dB, the amplifier voltage gain is 41dB; Set to 38dB, the amplifier voltage gain is 38dB; and so on. MODE SWITCH STEREO: Each channel is independent. CHA input signal output from CHA; CHB input signal output from CHB; and so on. MONO/BRDG: CHA input signal output from CHA and CHB; CHC input signal output from CHC and CHD.
- CLIP SWITCH Set to ON, the clipping limiter is on; Set to OFF, the clipping limiter is off.
4. SIGNAL INPUT
- Female XLR: Balanced audio input plug
5. GAIN AND SENSITIVITY
- The user can set the power amplifier's sensitivity through the switch on the back panel, so as to match with the third party devices. 29dB, 32dB,35dB, 38dB,41dB are selectable. Input signal: 1kHz sine wave, Amplitude value is RMS
